====== Exim4 - Reload the configuration ======

After making changes to exim.conf, you need to give the main exim pid a SIGHUP to re-exec it and have the configuration re-read. Sure, you could stop and start the service, but that's overkill and causes a few seconds of unnecessary downtime. Just do this:

<code bash>
kill -HUP `cat /var/spool/exim/exim-daemon.pid`
</code>

You should then see something resembling the following in exim_mainlog:

<code>
pid 1079: SIGHUP received: re-exec daemon
exim 4.52 daemon started: pid=1079, -q1h, listening for SMTP on port 25 (IPv4)
</code>