Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Networking - Tuning and Troubleshooting Network Cards - Intel Cards ======

[[Networking:Tuning and Troubleshooting Network Cards:Intel Cards:igc|igc]]

===== Intel igb and em Cards =====

Certain intel igb cards, especially multi-port cards, can very easily/quickly exhaust mbufs and cause panics, especially on amd64.

The following tweaks should help:

In /boot/loader.conf.local – Add the following (or create the file if it does not exist):

<file bash /boot/loader.conf.local>
kern.ipc.nmbclusters=”131072″
hw.igb.num_queues=1
</file>

That will increase the amount of network memory buffers, and make the card use one queue instead of multiple queues, to reduce the strain on the system.

<WRAP info>
**NOTE:**  The same settings can also apply to em cards, just use “em” in place of “igb” in the setting(s) above.
</WRAP>

----

===== Intel ix Cards =====

in /boot/loader.conf.local

<file bash /boot/loader.conf.local>
kern.ipc.nmbclusters=”262144″
kern.ipc.nmbjumbop=”262144″
</file>

Add a sysctl (system tunable):

<code>
hw.intr_storm_threshold=10000
</code>

If using VLANs with Intel 10 Gb ix cards, you may need to disable some features of the driver for VLANs to work correctly.

For instance, to apply these settings on NIC ix0, run the following.

<code bash>
ifconfig ix0 -vlanhwfilter
</code>

That alone should be enough, but in some cases you may also find that you need to disable TSO in addition to VLAN hardware filtering, which can be done like so:

<codde bash>
ifconfig ix0 -vlanhwfilter -vlanhwtso -tso
</code>

<WRAP info>
**NOTE:**  You can place these commands into a shellcmd tag to execute at boot time to make the change persistent.
</WRAP>


----

====== Flow Control ======

In some circumstances, you may wish to disable flow control.

The exact method of this depends on the hardware involved, but here are a couple examples.

All of these go in /boot/loader.conf.local:

For em cards:

<file bash /boot/loader.conf.local>
hw.em.fc_setting = 0
</file>

or for igp cards:


<file bash /boot/loader.conf.local>
hw.igb.fc_setting = 0
</file>

See https://docs.netgate.com/pfsense/en/latest/hardware/tune.html.