Differences

This shows you the differences between two versions of the page.

--- pfsense:pfblockerng:install_pfblockerng:increase_firewall_maximum_table_entries [2021/01/28 11:37] – peter
+++ pfsense:pfblockerng:install_pfblockerng:increase_firewall_maximum_table_entries [2021/01/28 18:38] (current) – peter
@@ Line 17: / Line 17: @@
 <WRAP info>
 **NOTE:**  Without increasing this value, DNS queries take much longer, causing webpages to load very slowly.
+If lots of blocklists are being used, then look at setting these slightly higher if you notice any slowness in DNS resolving.
+  * Be careful of setting this too high as it directly uses more RAM the higher you set it.
+  * In terms of RAM; 1 state == 1k of RAM, so 1 million states is 1GB of RAM.
 As a rough guide, set this value to the following, depending on how much memory there is.
@@ Line 25: / Line 30: @@
 |16GB|1200000|
 |32GB or Higher|2000000|
-If lots of blocklists are being used, then look at setting these slightly higher if you notice any slowness in DNS resolving.
-  * Be careful of setting this too high as it directly uses more RAM the higher you set it.
 </WRAP>