nas:qnap:recover_raid_or_move_data_from_broken_nas
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| nas:qnap:recover_raid_or_move_data_from_broken_nas [2021/10/07 22:19] – peter | nas:qnap:recover_raid_or_move_data_from_broken_nas [2021/10/07 22:21] (current) – [Connect the disks from the NAS to a PC running Ubuntu] peter | ||
|---|---|---|---|
| Line 25: | Line 25: | ||
| <WRAP info> | <WRAP info> | ||
| **NOTE: | **NOTE: | ||
| + | |||
| + | * If the computer does not have enough SATA ports or power connectors; then use some power splitter adapters and expansion cards as needed. | ||
| If the NAS only had a single disk, then this disk should be immediately accessible and no further steps in these instructions are needed. | If the NAS only had a single disk, then this disk should be immediately accessible and no further steps in these instructions are needed. | ||
nas/qnap/recover_raid_or_move_data_from_broken_nas.1633645176.txt.gz · Last modified: 2021/10/07 22:19 by peter